Technical Data; Before Starting; Cutting Grass - Ergotools Pattfield E-AGS 3,6 Li Mode D'emploi D'origine

Anleitung_E_AGS_3_6_SPK7:_

4. Technical data

Speed n :
0
Cutting width of the grass cutter:
Cutting width of the shrub shears
Cutting thickness of the shrub shears
Running time max.:
Battery pack: Li-Ion / 3.6 V d. c. / 1.3 Ah
Charging time:
Protection class:
L sound pressure level:
pA
L sound power level:
WA
Vibration a grass shears:
hV
Vibration a shrub shears:
hV
Weight:
Battery charger
Mains voltage
Output
Rated voltage
Rated current:
Sound and vibration were measured in accordance
with EN ISO 3744.

5. Before starting

5.1 Charging the battery pack (Figure 1/3)
Connect the charger to the charging station
(Figure 3).
Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Plug the battery charger in a socket-
outlet. The green LED (Figure 3 / Item 1) comes
on to indicate that charging voltage is available.
The battery pack is being charged. An empty
battery pack requires a maximum charging period
of 3 to 5 hours. The temperature of the battery
pack may rise slightly during the charging
operation. This is normal.
As soon as battery pack is fully charged, the red
LED (Fig. 3/Item 1) extinguishes
22.10.2009 8:50 Uhr Seite 9
If the rechargeable battery fails to charge, check
whether there is voltage at the socket outlet.
950 rpm
Timely recharging of the battery pack will help it
serve you well for a long time. Recharging is always
70 mm
necessary when you notice a drop in the toolʼs
100 mm
performance.
8 mm
Never allow the battery pack to become fully
60 min
discharged. This will cause it to develop a defect.
3-5 h
III 6. Operation
72.7 dB
The area to be cut must first be cleared of stones
92.9 dB
and other solid objects. The safety lock-off (Fig.
≤ 2.5 m/s
2
1/Item 3) prevents the tool being started
≤ 5.5 m/s 2
unintentionally. Activate the safety lock-off (Figure 1 /
Item 3) by pushing it forward and pressing the
1.4 kg
ON/OFF switch (Figure 1 Item 4) at the same time.
To switch off the tool, let go of the ON/OFF switch
(Figure 1 / Item 4).
230 V ~ 50 Hz

6.1 Cutting grass

Allow the grass cutter to glide above the ground. The
best results are achieved when the lawn is dry.
When you notice a drop in cutting performance, re-
6 V DC
charge the tool immediately so that the battery does
300 mA
not become fully discharged.
6.2 Trimming hedges
The tool can be used to trim small hedges and
shrubs.
Hold the tool slightly tilted in relation to the hedge
you want to cut.
First cut the sides from the bottom up, then cut the
top.
Watch out for foreign objects in or on the hedge
which could damage the blades.
When is the best time to trim hedges?
As a general rule, hedges which lose their leaves
in the autumn should be trimmed in June and
October.
Hedges which do not lose their leaves should be
cut in April and August.
GB
9