ACDelco ARL2025 Manuel Informations Du Produit page 8

INSTALLING OR REMOVING BATTERY PACK
TO REMOVE THE BATTERY PACK: Depress the battery release button (6), and pull
battery pack (7) out of tool.
TO INSTALL THE BATTERY PACK: Align the rails, on the tool with the four tabs
on the battery pack, and push battery pack into the tool until it locks in place.
NOTE: Make sure your battery pack is fully charged.
CAUTION
POWER ON / OFF
1. Press the 3-mode switch (4) on the grip to turn on the LED, turn on flashlight or
power off.
2. Remove the battery pack when not in use, before servicing and when changing
accessories.
BULB REPLACEMENT
Loosen the lens holder by screwing collar counter-clockwise. Pull the spare bulb out of
the spring holder. Insert the new bulb and tighten the collar by screwing collar
clockwise.
SWIVELING HEAD
The flashlight can be used as a standing model or as a handhold model.
1. Hold the swiveling head (1) in one hand and hold the back end of the flashlight in
the other.
2. Swivel the swiveling head (1) up and down until it clicks into position which you
needed.
3. If required, swivel the head back into its original position.
BULB STORAGE
1. Loosen the lens holder and remove it.
2. To remove the bulb, pull it up and out of the storage compartment.
3. Reinstall the lens holder.
1English1
ASSEMBLY
Always set switch (4) to off position when installing and
removing battery pack.
OPERATION
English -7