Connecting To Your Amplifier - Yamaha NS-3000 Mode D'emploi

Before making connections, make sure that the amplifier is switched off.
Connections
You need a commercially available speaker cable.
The size and/or material of a speaker cable affects on the sound quality. Therefore, we recommend you to purchase a
high-quality speaker cable to exert the performance of this unit.
15 mm
(5/8")
Good No Good
How to connect the speaker cables
Red (+)
Black (–)
2
Insert
Bare wire
8

Connecting to your amplifier

Remove 15 mm (5/8") of insulation from each end of the cables, and
twist the exposed conductors together neatly and tightly, as shown
left.
3
1
Loosen
Tighten
Insulation coating
1
Loosen the terminal knob on the rear
panel of this unit.
CAUTION
• When the terminal knob is completely
loosened, it will fall off. Keep the removed
knobs out of the reach of infants to prevent
accidental ingestion.
2
Insert the bare wire to the terminal hole.
NOTE
• Do not insert the insulation coating into the hole.
The sound may not be produced.
3
Tighten the terminal knob and secure the
cable.
Test the firmness of the connection by pulling lightly on
the cable at the terminal.