Operation - Waeco BordBar TB08 Notice D'utilisation

BordBar TB08
6

Operation

A
NOTICE!
 Ensure that only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
 Ensure that food or liquids in glass containers are not exces-
sively refrigerated. Liquids expand when they freeze and can
therefore destroy glass containers.
I
NOTE
Before starting your new cooler for the first time, you should clean
it inside and outside with a damp cloth for hygienic reasons (see
also chapter "Cleaning and maintenance" on page 20).
Fastening the cooler on the seat
➤ Place the cooler on a seat (passenger seat or the middle seat in the back).
➤ Thread the seat belt into one of the belt holders and fasten the cooler onto
the passenger seat (fig. 2 B, page 3) or the middle seat (fig. 2 C,
page 3).
➤ If you want to position your cooler between two seats (fig. 2 A, page 3),
use the fastening and carrying strap supplied (fig. 3 B, page 4) to do
this.
Switching the device on and off
➤ Plug the DC connection cable (fig. 3 A, page 4) into the cigarette lighter
socket in the vehicle.
➤ Push the slide switch into the required position.
✓ The cooler is switched on and starts cooling or heating the interior.
✓ The respective LED lights up.
➤ If you want to switch off the cooler, disconnect the plug.
Using the lock for the lid
You can keep the lid of the cooler open by hooking the chain in the screws
on the inside (fig. 4, page 4).
EN
Operation
19