Hkoenig TCP85 Manuel D'utilisation page 9

PHOTO 11&12 - Pull out filter, pat the filter first then using warm, soapy water to wash the filter
and ensure it is completely dry before using it again. The cleaner filter, the better the product will
perform. It is very important that the filter is correctly in position before use.
CAUTION: Filter must be dry before re-assembling.
图 10
PHOTO 11 PHOTO 12
IMPORTANT: Maximum dust collection will only be obtained with clean filter and an empty
Cyclone bin. If dust begins to fall back out of the product after it is switched off, this indicates
that the cyclone bin is full and requires emptying.
Never immerse the product in water. A damp cloth and soapy water should be used
to clean the exterior of the motor section. Always ensure the product is completely dry
before re-use or storing.
ACCESSORIES.
PHOTO 13&1$&15&16 -Take out the crevice tool and small brush from charging base. Crevice
tool and small brush can be directly inserted to suction hole. After using place accessories back
into the charging base and click firmly into position
PHOTO 13 PHOTO 14