Attach Mounting Brackets; Accessories - Whirlpool GLADIATOR PREMIER JUMBO GAJG36FDZW Instructions D'assemblage

Be sure the GearWall ® panels or GearTrack
installed with mounting screws in every slot and at every stud
location with a maximum of 24" (60.96 cm) horizontally between
screws.
18" (46 cm)

Attach Mounting Brackets

F7
F7 Carriage-head bolt (9)
F8 Washer (9)
IMPORTANT: There are slots in back panels (AAA, CCC, and DDD) to
attach the mounting brackets (P8).
1. With the mounting bracket rim pointing down, align the three
bracket holes with the slots in back panel (AAA), as shown.
2. Working from the back, insert carriage bolts (F7) through the
bracket and into top back panel (AAA).
3. Working from the cabinet interior, fasten each bolt with a
washer (F8) and a flange nut (F2). Fully tighten the bolts.
P2
P8
AAA
BBB
A. Bracket rims pointing down
4. Repeat steps 1 and 2 to attach the center and bottom mounting
brackets (P8) to the back of the cabinet.
NOTE: Hand tighten the nuts attaching the center and bottom
brackets. These brackets will need to be adjusted to mount the
cabinet on the wall.
6
® channels are
F8 F2
⁵⁄₁₆
F2 " flange nut (9)
AAA
P1
P8
Mount the Cabinet to GearWall
®
GearTrack Channel
NOTE: The three nuts on the center and bottom mounting brackets
must be loose enough to allow the brackets to move in the slots.
1. Close the cabinet doors.
2. Determine cabinet mounting location on GearWall
GearTrack ® channel.
3. Using two or more people, engage the top bracket (P8) into the
slots by lifting up, pushing toward the wall and lowering the
bracket rims into the slots, as shown.
4. Make sure the top bracket is fully engaged in the slots, as shown.
A
A. Bracket rim
5. Open the cabinet doors.
6. From inside the cabinet, grasp the bolts in the center bracket and
adjust the bracket until it aligns with the slot in the GearWall
panels or GearTrack
7. Push the cabinet toward the wall and lower the center mounting
bracket into the slots.
8. Make sure the center bracket (P8) is fully engaged in the slot, as
shown.
9. Repeat for the bottom bracket (P8).
10. Using a ¹⁄₂" wrench, fully tighten the nuts attaching the center and
bottom brackets.

ACCESSORIES

P1
The Gladiator ® GearRod accessory provides a hanging solution for
heavy outdoor gear and other seasonal items, freeing up space in
your household closets for everyday items. It attaches to any of the
adjustable shelves or to the top of the cabinet. The Gladiator
GearRod holds up to 100 lbs of seasonal clothing and outdoor gear
wear.
A
To order accessories, call 1-866-342-4089 and ask for the accessory
part number listed below or contact your authorized Gladiator brand
dealer. In Canada, call 1-800-807-6777.
GearRod Accessory
Order Part # GAAC36GRDSS
®
Panels or
B
B. Mounting bracket
fully engaged
®
channels.
®
panels or
®
®