Agilent Technologies Turbo-V 81-T Mode D'emploi page 199

Compliance with:
Storage temperature
Input
Lubricant
Installation category
Pollution degree
Storage temperature
Weight kg (lbs):
* (According to standard DIN 28 428, the base pressure is that measured in a leak-free test dome, 48
hours after the completion of test dome bake-out, with a Turbopump fitted with a ConFlat flange and
using the recommended pre-vacuum pump)
When the Turbo-V 81-T has been stored at a temperature less than 5 °C, wait
NOTE
until the system has reached the above mentioned temperature.
Turbo-V 81-T User Manual / 87-900-984-01
UNI EN 292-1
UNI EN 292-2
EN-CENELEC 55011
IEC 1000-4-2 (ex 801-2)
IEC 1000-4-3 (ex 801-3)
IEC 1000-4-4 (ex 801-4)
EN 61010-1 (IEC 1010-1)
EN 1012-2
-20 °C to +70 °C
60 Vac, three phase,
1350 Hz (max)
50 W max
permanent lubrication
II
2
- 20 °C to + 70 °C
ISO 63: 1.83 (4.03)
KF 40: 1.80 (3.97)
CFF 4.5": 2.62 (5.78)
CFF 2.75": 2.59 (5.71)
(E)
Technical Information
199/228
17