Publicité
Les langues disponibles
Les langues disponibles
GB
In-house manufacturing
Depending upon the existing plug system, the connection
wires can be manufactured by an electrician himself.
a. Loosen the two screws
lid
.
1
b. Open the strain relief clamp
c. Cut the device supply wire at the desired point near
the device plug and strip the two ends of the wire.
• The length of the wire before the PRCD-S must be a
minimum of 1.5 m + 10 %.
• The length of the wire after the PRCD-S must be a
minimum of 1.5 m.
d. Strip single cores and install wire-end sleeves
(max. diameter 2.5 mm²).
e. Push the protective rubber sleeves
the wires.
f. Connect the connection cable to the terminal clamps
beginning with the ground wire.
g. Observe: input side
(arrow direction = direction of current flow)
h. Input side: connect Phase L to terminal
N to terminal
B
in the housing and lift off
3
and remove completely.
5
over the ends of
4
, neutral wire
C
i. Output side: connect neutral wire N to terminal
Phase L to terminal
j. Attach the connecting wires and protective rubber
sleeves
with the strain relief clamps.
4
Check protective rubber sleeves and strain relief clamps
for proper fit.
k. Place the lid
on the housing
1
with a torque of 1 Nm.
3
The wire lengths of the PRCD-S made by the manufacturer
can deviate from the dimensions listed above.
Repeat test
The PRCD-S must be checked regularly.
,
Instructions for this can be found at www.kopp.eu.
A
, ground wire PE to terminal
C
and tighten the screws
2
,
B
A
39
Publicité
