Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
BATTERY REPLACEMENT
The battery should last the service life of the unit. Service life is
dependent on a number of factors including but not limited to the
number of recharge cycles, and proper care and maintenance of the
battery by the end user. Contact manufacturer for any information you
may need.
SAFE BATTERY DISPOSAL
Contains a maintenance-free, sealed, non-spillable, lead
acid battery, which must be disposed of properly. Recycling
is required. Failure to comply with local, state and federal
regulations can result in fines, or imprisonment.
Please recycle.
WARNING – To reduce the risk of serious injury or property
damage:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with
heavy-duty electrical tape to prevent shorting (shorting can result
in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
12 VOLT DC ADAPTER PLUG FUSE REPLACEMENT
The fuse in the plug end of the 12 Volt DC Adapter protects the
adapter's charging circuit. If the built-in 120 Volt AC Charger operates,
but the DC charging adapter does not, then this fuse may be opened
(blown).
To replace the fuse:
1. Unscrew the end cap of the DC plug (counterclockwise).
2. Remove spring center contact and fuse.
3. Check fuse with a continuity checker.
4. If blown, locate a replacement 2 amp.
5. Replace the fuse, spring, contact and end cap.
6. Screw end cap clockwise until it is finger tight – DO NOT OVER-
TIGHTEN.
7. Test for proper operation of the 12 volt DC charging adapter.
Troubleshooting
Problem
Unit will not charge
Unit fails to jump-start
20
Possible Solution
Make sure all of the unit's functions are
turned off.
Make sure a suitable gage extension
cord is properly connected to both the
unit and a functioning AC outlet.
or
Make sure the 12 volt DC charging
adapter is properly connected to both
the unit and a functioning DC power
source.
Check the connection to the AC or DC
power source.
Confirm there is a functioning AC or
DC current.
Check that the fuse in the 12 Volt DC
Adapter is not blown.
Make sure unit's Jump Starter Power
Switch is in the on position.
Make sure a proper polarity cable
connection has been established.
Make sure the unit is not being operated
in the Compressor mode.
Publicité
Table des Matières
