Before You Start - Pioneer SX-20-K Guide Rapide

Before you start

Loading the batteries
The batteries included with the unit have been provided to allow you check
product operation and may not last long. We recommend using alkaline
batteries that have a longer life.
WARNING
• Do not use or store batteries in direct sunlight or other excessively hot
place, such as inside a car or near a heater. This can cause batteries
to leak, overheat, explode or catch fire. It can also reduce the life or
performance of batteries.
CAUTION
• When inserting the batteries, make sure not to damage the springs on
the battery's  terminals.
• When disposing of used batteries, please comply with governmental
regulations or environmental public institution's rules that apply in your
country/area.
To turn the power on

Press  STANDBY/ON button on the remote control or /I
STANDBY/ON button on the front panel.
• If the unit is in the standby mode, press  STANDBY/ON button on the
remote control.
Set the power to Standby

Press  STANDBY/ON button on the remote control.
The next time you wish to turn on the power, press  STANDBY/ON
button on the remote control.
• If the front panel's /I STANDBY/ON button is pressed, the power
will be turned off. In this case, if the power is off, pressing the remote
control's  STANDBY/ON button will not turn on the power. To turn on
the power again, press the front panel's /I STANDBY/ON button.
Canceling the Auto Power Down
When this receiver is not used over a period of several hours, it will power
down automatically. The automatic power-off timer is set to six hours
under factory settings, and the timing can be changed or the power-off
function switched off altogether.

Press APD repeatedly to select "OFF".
You can select 2, 4 or 6 hours, or OFF (if no automatic shutoff is desired).
4
En
Operation
Controls for other Pioneer components
When the NETWORK button is pressed to switch the unit's input to
NETWORK input, the " a " buttons can be used to operate certain other
Pioneer network audio players. Likewise, when the SACD/CD button is
pressed to switch the unit's input to SACD/CD input, the " b " buttons
can be used to operate certain other Pioneer SACD/CD players.
A
Switches the receiver between
standby and on.
E
Switches between the various
surround modes.
F
Use to listening to the FM/AM radio.
C
Use to set the listening volume.
B
Press to select an input source.
D
Use to adjust Bass or Treble.
b
Use to control Pioneer SACD/CD
players.
a
Use to control Pioneer network
audio players.