Bien-Air Dental DMX2 Plus Mode D'emploi page 6

Description ref. Diagram Specification
DMX2 Plus REF 1501393-001 / DMX2 Pro REF 1501384
Voltage Input -
Speed reference Input
MUX IN Motor Input
Rotation (CW/CCW) Input
Brightness Input
Pneumatic pressure Input
reference
Motor Power Output
Motor Light Output
MUX OUT Motor Output
RS-232
Voltage converter REF 1500580-001
Voltage Input
Voltage Output
Voltage Output
Dual Motor Switch REF 1500554-001
IN motor Input
MUX Control Input
EV In Input
OUT motor 1 Output
OUT motor 2 Output
Notes
32 Vdc +/- 10%
0 to 5 Vdc (linear) Pull-down Input
0 or 5 Vdc (TTL) Pull-down Input
0 or 5 Vdc (TTL) Pull-down Input
0 to 5 Vdc Pull-up Input
(16 output levels)
0 to 3 bar (0 to 300 kPa,
0 to 43.5 psi)
Phases A, B, and C
L+ / L-
24 Vdc, Max. current = 100mA
Digital interface
22 to 26 Vac or 22 to 37 Vdc
24 Vdc (24W peak / 12W cont)
32 Vdc (130W peak / 60W cont)
3 motor phases: A, B, C Max. relay current
(Max. current = 6A)
2 light connections L+, L-
(Max. current = 3A)
24 Vdc, 200mW Max. relay current
Solenoid valve input (24 Vdc)
3 motor phases: A, B, C Max. relay current
(Max. current = 6A)
2 light connections
3 motor phases: A, B, C Max. relay current
(Max. current = 6A)
2 light connections
Operating mode selection by DIP-Switches
The 4 DIP-Switches are used to configure the system, and in particular to select
the operating mode (see table below). For more information and technical sup-
port, please contact your Bien-Air Dental SA dealer.
1 2
Mode
The serial mode protocols for mode 3 are available on request from your Bien-
Air Dental SA dealer.
0 = OFF 1 = ON
Mode Dip switches
1 2 3 4
0 0 0 X X Electric mode
1 0 1 X X Pneumatic mode
2 1 0 X X Pneumatic mode
3 1 1 X X Serial mode (RS232)
All X X 1 X Status frame auto-send
All modes X X X 1 Light delay (1 = enabled, 0 = disabled)
except 3
Mode 3 only 1 1 X 1 Frame check (0 = checksum, 1 = CRC)
3
Function
Description
from 100 rpm to 40 000 rpm
from 100 rpm to 40 000 rpm
with electric limitation
(1 = enabled, 0 = disabled)
4
4