Inspectation, Maintenance And Storage; Scooter Specifications - OXBOARD E-KICK2 Mode D'emploi

10. INSPECTION, MAINTENANCE AND STORAGE
Your E-Kick2 requires routine inspection and maintenance. This
chapter escribes maintenance steps and important operating tips.
Before you perform the following operations, ensure the power and
charging cable is disconnected.
Inspecting and Cleaning your E-Kick2
Disconnect the charger and turn off your E-Kick2.
Routinely check the body of the E-Kick2 and tires for damage or
excessive wear. Avoid using water or other liquids and cleaners on
the scooter for cleaning. Wet a clean cloth with clean soapy water,
rinse the cloth thoroughly, and wipe the body of the scooter making
sure that water does not get into the power button, charging port,
the foot mats, or tires.
Storing your E-Kick2
Fully charge your battery before storing.
If you are storing your scooter for an extended period of time, please
fully charge your E-Kick2 at least once every three month.
If the ambient temperature of the storage location is below 0°,
please do not charge. You must bring the E-Kick2 into a warmer
environment before charging. Check under Battery Information and
Specifications for more details. To prevent dust from getting into
your E-Kick2, try wrapping it or sealing it with its original packaging.
Store your E-Kick2 indoors, in a dry and suitable temperature.
NOTE: Users who disassemble the scooter will forfeit their
right of warranty.

11. SCOOTER SPECIFICATIONS

Net Weight: 11kg
•
Load: 100 kg
•
Max. Speed Limit: 10 km/h , 20 km/h , 25 km/h
•
Range: Appr. 5 km. Depending on the conditions
•
and use.
Max. Climbing Limit: 15 degree
•
Battery: Lithium-ion, 5.0 Ah, 36 V
•
Input: DC 42V 1.5A
•
Power Requirement: AC 100-240V / 50-60Hz
•
Size (fold): 114 x 43 x 41 cm
•
Size (unfold): 97.5 x 43 x 114 cm
•
Platform Height: 12 cm
•
Tire: Front inflatable air tire, back motor is solid
•
tire
13