Cleaning And Storage; Description Générale Fig - Philips SatinShave BRL180 Mode D'emploi

Place the appliance on your skin in such a way
that the attachment or accessory is in full con­
tact with the skin 5ig.
When you use the appliance on sensitive areas,
stretch the skin with your free hand. When you
use the appliance on your underarms, raise
your arm and put your hand on the back of
your head to stretch the skin 5ig.
Move the appliance slowly against the direction
of hair growth 5ig.
Note: If you move the appliance over your skin too
fast, you may not obtain a smooth result.
Shaving head
You can use the shaving head to shave your legs
and body.
Note: Always check the foils before use. If they are
damaged in any way, replace them right away see
'Replacement' .
Skin stretcher cap
You can attach the skin stretcher cap onto the
shaving head to make the hairs stand upright dur­
ing shaving. This makes it easier to remove them.
Bikini trimmer head BRL
only
You can use the bikini trimmer head to trim hard-
to-reach areas in the bikini zone.
Place the bikini trimmer head flat onto the skin to
trim 5ig. . Place the bikini trimmer head perpen­
dicularly onto the skin for styling and shaping 5ig.
.
Bikini trimmer comb BRL
only
You can attach the bikini trimmer comb onto the
bikini trimmer head to trim hairs in the bikini area to
a length of mm 5ig.
Small shaving head BRL
You can use the small shaving head for precision
shaving of small areas of your body.
If the hairs in the area to be shaved are longer than
mm, first pretrim them with the bikini trimmer
head.
Place the small shaving head flat onto the skin 5ig.
.

Cleaning and storage

Keep the adapter dry.
Switch off the appliance.
Use the cleaning brush to brush away any hairs
that have collected under the trimmer of the
shaving head.
Push the foil holder release slide on the back of
the shaving head to the right to remove the foil
holder 5ig.
Clean all parts of the shaving head with the
cleaning brush, except the foils.
BRL only: To clean the small shaving head,
hold the sides of the top part and pull it off the
bottom part 5ig.
part and the cutter of the bottom part with the
cleaning brush 5ig.
parts.
Rinse the foil holder, heads and accessories
under the tap. Shake them firmly to remove
water drops.
Let all parts dry completely.
Place the foil holder back onto the shaving
head 'click' .
Put protection/travel caps or combs on the
heads to prevent damage to the heads when
you store them.
Store the appliance, its heads and accessories
in the pouch.
Note: Lubricate trimmer teeth and foils with a drop
of sewing machine oil every six weeks for optimal
performance.
Replacement
To buy accessories or spare parts, visit
www.shop.philips.com/service or go to your Philips
dealer. You can also contact the Philips Consumer
Care Centre in your country see the worldwide
guarantee leaflet for contact details
5or optimal performance, we advise you to replace
the foils and cutters of the shaving head every two
years. If you use the shaving head twice or more
times a week, replace the cutting unit more often.
Always replace the foils and cutters with an original
set BRL
5rançais
Introduction
5élicitations pour votre achat et bienvenue dans
l'univers Philips ! Pour profiter pleinement de l'as­
sistance offerte par Philips, enregistrez votre pro­
duit à l'adresse suivante :
Description générale fig. 1
Poignée
Bouton marche/arrêt
Indicateur de charge
Bouton de déverrouillage
Prise pour petite fiche
Tête de rasage
Tondeuse
6rilles
Bouton de déverrouillage du support de grille
Capot de protection avec verrouillage
Capot permettant de tendre la peau
Petite tête de rasage BRL
Capot de protection pour petite tête de rasage
BRL uniquement
Tête de tondeuse bikini BRL
quement
Peigne de tondeuse bikini BRL
quement
Brossette de nettoyage
Adaptateur
Non illustré : Trousse
Charge
Remarque : Rechargez complètement l'appareil
avant la première utilisation.
.
.
. Brush the inside of the top
.
.
.
and then rinse both
www.philips.com/welcome
uniquement
, BRL
.
, BRL
, BRL
only
.
uni­
, BRL uni­