EIBENSTOCK TwinMix 1800 Notice Originale page 18

paddle. The wiper prevents that mixing material remains sticking to the
bucket edge.
The wiper should be removed for mixing of coarse-grained materials
(e.g. screed).
IMPORTANT!
The use of chemical products or solvents can impair the
!
properties of the mixing bucket and the machine.
Before using the TwinMix 1800, check that the products to
be mixed are compatible with the properties of the machine.
Remixing function:
If you want to mix material in the bucket again, move the machine unit with
pressed ON/OFF switch down. With this, the mixing station is turned on
early and thus permits immersion of the mixing tools into already mixed
mixing materials.
Removing the Mixing Bucket
Turn the machine off and wait until the stirrers have stopped.
Move the complete mixing unit out of the button, until the slide locks at
the end position.
Move the bucket car out of the mixing station.
CAUTION!
Do not lift full mixing buckets alone from the bucket car!
Tool Protection
Wrong handling can cause damages on the tool.
Therefore, please always observe the following instructions:
Do not stress the tool to such an extend that it stops by itself.
Electronic: In case of overload due to too large feed force, the
electronic will cut OFF the machine. After discharge and
switching ON you can continue drilling again.
18