EIBENSTOCK TwinMix 1800 Notice Originale page 16

When working with this machine wear ear protectors, goggles,
protective gloves and protective boots.
For further safety instructions, refer to the enclosure.
Assembly of the Device
The mixing station is delivered nearly ready for operation. Only the
handlebar of the transport trolley must be installed. For this, insert the
handlebar into the two pipe ends of the trolley and secure it with the
provided bolts and nuts.
Transport of the Device
The mixing station can be transported easily complete with the transport
trolley or also without the trolley.
With the transport trolley, use the handlebar to raise the unit in closed
condition.
Without the transport trolley, hold the two handles (3) and tilt the unit to the
rear.
Before starting the machine check the correspondence between voltage
and frequency according to the data mentioned on the identification plate.
Voltage differences from + 6 % and – 10 % are allowed.
The TwinMix 1800 is made in protection class I.
Only use extension cables with a sufficient cross-section. A cross-section
(min. 2.5 mm²) which is too small could lead to an excessive power loss
and to an overheating of motor and cable.
Electrical Connection
16