Hama 00176576 Mode D'emploi page 3

Speci cations in accordance with
Regulation (EU) 2019/1782
Manufacturer's
name or trade
mark, commercial
registration number
and address
Model identi er
Input voltage
Input AC frequency
Output voltage /
Output current /
Output power
Average active
e ciency
E ciency at low load
(10 %)
No-load power
consumption
5. Getting started and operation
Warning
• Only operate the product from a socket that has
been approved for the device. The socket must
be installed close to the product and must be
easily accessible.
• Disconnect the product from the power supply
using the On/Off switch – if this is not available,
unplug the power cord from the socket.
• If using a multi-socket power strip, make
sure that the total power consumption of all
connected devices does not exceed the power
strip's maximum throughput rating.
• If you will not be using the product for a
prolonged period, disconnect it from mains
power.
Hama, HRA12159,
Dresdner Str. 9,
86653 Monheim
KA1201A-1201000EU
100-240 V
50/60 Hz
12.0 V DC / 1.0 A /
12.0 W
84.11 %
78.9 %
0.08 W
It's so simple:
• Download the Hama Smart Solution app from
the Apple App Store or on Google Play.
• Start the Hama Smart Solution app
• If you're using it for the rst time, you'll have to
register and create a new account. If you already
have an account, log in using your login details
• Connect the WiFi camera to the included power
supply unit, and connect the power supply unit
to a properly installed and easily accessible
mains socket.
• Wait a moment until the camera emits a signal
tone and the LED begins to ash red.
• Click + in the upper-right corner in the app,
and in the list select 'Cameras' followed by
176576/77.
• Con rm that the camera is ashing.
• Now follow the remaining instructions on your
smartphone's screen and scan the QR code
displayed on your smartphone with the WiFi
camera. When you hear an acoustic signal,
con rm this.
• Now enter the name of your WiFi network and
the password, and con rm.
• The camera will now be connected. Once the
connection has been established, the LED stops
ashing and emits a constant blue light.
• Now you can set up, control and con gure your
WiFi camera using the app.
Note: Pairing restart
First remove the rubber protection on one side of
the camera. Now press the Reset button with a pin
(or similar thin object) until you hear an acoustic
signal. As soon as the LED begins to ash red, you
can make another pairing attempt.
6. Care and Maintenance
Note
Disconnect the product from the mains before
cleaning it or if it is not going to be used for a
long period of time.
• Only clean this product with a slightly damp,
lint-free cloth and do not use aggressive cleaning
agents.
• Make sure that water does not get into the
product.
3