EFALOCK Professional 14102164 Mode D'emploi page 7

ENGLISH ENGLISH
WARNINGS
THIS DEVICE MAY BE USED BY CHILDREN AGED 8 AND UP AND BY PEOPLE WITH PHYSICAL, SENSORY OR MENTAL
LIMITATIONS OR A LACK OF EXPERIENCE AND KNOWLEDGE PROVIDED THAT THEY ARE UNDER SUPERVISION
OR HAVE RECEIVED INSTRUCTIONS ON HOW TO USE OF THIS DEVICE SAFELY AND THEY UNDERSTAND THE
DANGERS INVOLVED. CHILDREN SHOULD NOT PLAY WITH THE APPLIANCE. CLEANING AND MAINTENANCE BY
THE USER MAY NOT BE CARRIED BY UNATTENDED CHILDREN. IF THE POWER CABLE IS DAMAGED, IT MUST BE
REPLACED BY THE MANUFACTURER, ITS SERVICE DEPARTMENT OR A PERSON QUALIFIED TO DO SO IN ORDER
TO AVOID ANY HAZARD.
WARNING: DO NOT USE THIS APPLIANCE NEAR BATHTUBS, SHOWERS, SINKS OR OTHER
CONTAINERS CONTAINING WATER.
To avoid any danger or accident, please read all the instructions before using the appliance.
DIRECTIONS FOR USE
Make sure the appliance is properly connected.
1. Place wet rolled towels onto the wire basket inside the towel warmer and close the door.
2. Press the heat switch to turn the appliance on. A light indicator will light up to indicate that the appliance is
heating up. Once the right temperature has been reached inside the towel warmer, it will be automatically
maintained. If the temperature inside the towel warmer drops, the appliance will start to heat up again.
3. Press the UV Switch on to activate the sterilizer.
4. Turn off the towel warmer before using the towels. The light indicator will turn off. The appliance door can
now be opened. Use tongs to remove the towels while maintaining a suitable distance to avoid any risk of
burning.
5. When heating the moist towels, water vapour is produced. This is collected by the water collecting tank (E).
Empty it after each use.
Position the towel warmer on a stable and dry surface, away from any explosive or flammable objects. Ensure
there is a distance of approx. 30cm between the towel warmer and the wall.
Before placing any towels inside the towel warmer, wet them and then wring them out.
Do not place any flammable or explosive objects inside the towel warmer to prevent accidents.
CLEANING THE DEVICE:
- Before cleaning, be sure to unplug the appliance from the mains, and wait until the appliance has cooled
down.
- Clean the appliance with a neutral, acid-free and non-corrosive cleaning product.
- Wipe with a soft cloth.
- Remove the drip tray, empty it and leave it to dry.
REPLACING THE UV BULB:
- Before replacing the bulb, be sure to unplug the appliance from the mains, and wait until the appliance has
cooled down.
- Unscrew and remove the UV bulb. Replace it with a new E17, 3W, 240nm UV bulb or equivalent.
OPERATING ISSUES:
- Excessive humidity inside the towel warmer or towels that won't heat up are usually due to towels being too
damp. Be sure to wring them out sufficiently before placing them inside the towel dryer.
- If the door does not shut properly or you notice steam escaping from the towel warmer, check that the door
seal is positioned properly. If necessary, press on the door to align the seal with the groove in the door.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical equipment, especially in the presence of children, it is essential to observe basic safety
TOWEL WARMER