Adapting The Hob To Different Types Of Gas - Candy PLC 2200 Notice D'emploi

Adapting the hob to different types of gas

To adapt the Hob for use with different types of gas, carry out the following instructions:
— remove the grids and burners
— insert the hexagonal spanner (supplied) into the burner support (Fig. 5)
— unscrew the injector and replace it with one suitable for the gas to be used (see
Table of gas consumption)
— carry out regulation of the burner.
Table of gas consumption
G20/G25
Working Ø injector
Ø injector
burner 1/100 mm 1/100 mm
large back right 120
large front left 127
medium 93
small 80
double ring 2x94
maxi 2x94
Regulating the burners
For maximum efficiency from the burners, the correct combustion of the flame is neces-
sary (see table of gas consumptions quota "X"). A good flame must be well aligned and
without yellow tips (Fig. 7/B). If there is insufficient air, the flame will be uneven with yel-
low tips (Fig. 7/A). If there is too much air, the flame will be very short and bright (Fig.
7/C). In these cases the combustion
must be adjusted by re-fitting the carburation tube to the Venturi (where there is insuffi-
cient air) or removing the carburation tube (in the case of too much air). To position the
carburation tube, the fixing screws must be loosened, and retightened when the sati-
sfactory combustion is obtained.
G30 G20/G30
Qn l/h
kW G20 G30
80 2,65 252 193
84 2,95 281 215
61 1,5 143 109
54 1,1 105
2x65 3,3 314 238
2x65 3,3 314 238
Hexagonal spanner
1W = 0,860 kcal/h
G25
g/h
g/h Qn l/h
G31 kW G25
189 2,5 277
211 2,8 310
107 1,45 161
80 79 1,05 116
236 3,1 314
236 3,1 314
27
Quota «X» depending
on type of gas
G20 G30 G25
air
Qmin. air air
regul.
kW regul. regul.
0,650 4 mm 4 mm
2 mm
0,650 4 mm 2 mm 4 mm
0,380 2 mm 5 mm 2 mm
0,280 6 mm 4 mm 6 mm
0,900 13 mm 0 mm 15 mm
0,900 13 mm 0 mm 13 mm
Fig. 5
G31
air
regul.
5 mm
5 mm
7 mm
6 mm
15 mm
13 mm