Hartke Bass Attack 2 Mode D'emploi page 6

Callouts
13. AMOUNT - This control knob is used to set the depth of boost or cut of the SHAPE filter. The AMOUNT knob provides +15db of
boost, or -25dB of cut.
14. OVERDRIVE Switch - Footswitch used to engage the overdrive stage of the Bass Attack 2.
15. Overdrive LED - This LED illuminates red when the Overdrive section is engaged.
16. TONE - Adjusts the high frequency response of the effected signal. Turning the knob clockwise brightens the sound, conversely turn-
ing the knob counter-clockwise rolls-off the high frequencies.
17. DRIVE - Control knob used to adjust the amount of the tube-emulation overdrive circuit. As the knob is rotated clockwise, the
amount of overdrive increases.
18. MIX - Control knob adjusts the blend between the dry signal and overdriven signal.
19. IN/OUT Switch - When the switch is IN position, the Direct Output signal is a parallel the pedal IN jack, with no effects. When the
switch is in the OUT position, the Direct Output the signal is parallel the pedal OUT jack.
20. LIFT/GROUND Switch - To remove hum at the XLR ouptut, set the switch to the LIFT position to engage a ground lift.
21. OUT - 1/4" jack carrying the line-level output signal (affected or bypassed signal) of the Bass Attack 2 pedal.
22. DIRECT OUTPUT - XLR balanced output connector carrying the mic-level output signal, either with effect (parallel OUT jack) or off
the input (parallel IN jack), depending on the position of the IN/OUT switch.
23. Battery Door - If powering the Bass Attack 2 pedal with batteries, insert two AA batteries ensuring that the positive (+) and negative
(-) ends are correctly positioned.