König Electronic CMP-BLUEHS11 Mode D'emploi page 4

Function
Answer call
Reject call
End call
Voice transfer
Mute microphone
Cancel mute
Remarks:
* Not all mobile phones support all the functions listed above. Please refer to your mobile phone's user manual.
* When the volume is adjusted to maximum or minimum, you will hear an indicator tone of "Ding-Dong".
* For some mobile phones, when you press the button to answer the phone, the conversation will be sent to
the phone. If this happens, you can switch the call to the headset by using the conversation switch button or
trough operating on the mobile phone. Please refer to your mobile phone's user manual for further information.
It means you can check your phone setting and transfer the conversation back to the Bluetooth headphone.
5. Wearing the headset
Hook the headset over both ears by using both hands (see picture).
6. Playing music
When the headset connects with the mobile phone or Bluetooth transmitter, you can enjoy music wirelessly
through the headset.
Function
Volume up
Volume down
Pause
Play
Revert
Last song
Next song
Remarks:
* For some mobile phones, when you play music, the music will be transmitted to the speaker of the phone.
In this case you should choose "transmit the sound through Bluetooth" in the phone settings. Please refer
to the manual of the phone.
* When the volume of the headset is adjusted to maximum or minimum you will hear a tone of "Ding-Dong".
* To remotely control the functions of last song / next song / pause / revert, your mobile phone needs a Bluetooth
transmitter which supports AVRCP. Please refer to the manual of the mobile phone for further information.
7. LED indicator
Pairing the Bluetooth device
LED indicator
Red and blue LEDs blink alternately
Blue LED blinks twice every 2 seconds
Status of the headset
Ringing
Ringing
Conversation mode
Conversation mode
Conversation mode
Conversation mode
(mute)
Status of headset
Playing music Move switch two to + and then release (or hold) it
Playing music Move switch two to – and then release (or hold) it
Pausing music
Short press ]
Playing music
Pause
Short press ]
Playing music Move switch one to ˘ and then release it
Playing music Move switch one to ¯ and then release it
Status of the headset
Pairing mode
Standby mode (not connected with the Bluetooth device)
Operation
Short press O
Press O for 2 seconds and release until a tone is heard
Short press O
Press O for 2 seconds and release until a tone is heard
Short press O twice, the headset will emits 2 tones
every 10 seconds
Short press O twice
Operation
I
I
4