Charging The Headset - König Electronic CMP-BLUEHS11 Mode D'emploi

Charging the headset

Before using for the firsttime, please charge the battery for a minimum of 4 hours.
If during succeeding uses you hear 3 "beep" warning tone every 20 seconds and the red LED blinks twice, it
means the battery power is low and the battery needs to be charged.
The steps for charging the battery are as follows:
Step 1: Pull up the rubber cover of the charging port
Step 2: Plug the USB cable into a USB port of the PC
Step 3: Connect the USB cable to the charging port of the headset.
When the red LED is on, the headset is charging
When the red LED is off, the headset is fully charged
Step 4: It will take about 3 hours to charge the headset, when charging is done, pull out the charger.
Functions of the CMP-BLUEHS11
1. Switch one
¯ : Next song
I
: Pause/Mute microphone
]
˘ : Last song
2. Switch two
–: Volume down
O : Multi-function key (switch on/off, answer/end/reject a call, voice dial/voice transfer/redial
3. LED indicator
4. Charging port (plugged with a rubber cover)
5. Built-in microphone
6. Loudspeaker
ENGLISH
.
2