Washing Instructions - KIKKA BOO SPORT Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
4. Age group instructions
Instructions for Group 0 child safety seat (0-9 KGS)
Step 1. For group 0, the child safety seat must be used in the most reclined position (see Fig 1 a). The safety seat must never be used
in any other position(see Fig 1. b). To adjust the reclining position of the safety seat, pull the red handle (J) forward until the backrest
is in the most reclined position. Adjust the position of the base as shown, and then press the red button, until heard "clicking" sound.
Step 2. The child seat must be always rear-ward facing (Fig. 3). If your car has airbag on the passenger seat, the safety seat must only
be used on the rear seats in the vehicle (Fig. 1 c).
Step 3. Secure the safety seat onto the car seat using the car seat belt (see Fig 3).
Step 4. Pass the lap part of the seat belt under the base of the safety seat into the two points marked by a blue label (A) and fasten
the clip to the corresponding buckle (M).
Step 5. Pass the upper diagonal part of the belt in the upper guide (B).
Step 6. Take the red Lock-o clip ( D) and attach it to the shoulder belt directly above the buckle (Fig.4.) .
Step 7. Make sure that the belt is not twisted and strongly tightened before the Lock-o clip is fastened.
Instructions for use as Group I child safety seat (9 to 18 KGS)
Step 1. The basic wedge must be in position A when used forward facing.
Step 2. Fasten the child seat in forward facing position on rear seat of your car using the 3 point belt system which is installed in the car.
Step 3. Pass the 3 point belt system (lap and shoulder belt) through the red marked openings (Fig.4) (K1and K2) AND THROUGH THE
UPPER GUIDE (B). Fasten the buckle (M) in the lock until a click is heard (Fig 5.).
Step 4. At the same time the lap belt is pulled through the 2 plastic holes.(Fig.4).
Step 5. Place and fasten the red Lock-o clip (D) on the shoulder belt directly above the buckle. (Fig. 5).
IMPORTANT - DO NOT USE FORWARD FACING BEFORE THE CHILD'S WEIGHT EXCEEDS 9KGS.
WARNING:
The forward facing position in group 1 can only be done when the child has reached a weight over 9kgs and less than 18kgs.
Your child seat can only be tted into the front passenger seat of a car with a lap and diagonal seat belt and without an airbag.
Do not use any load bearing contact points other than those described in the instructions and marked on the child restraint.
The vehicle seat buckle is not positioned in or in front of the speci ed belt guide.

5. Washing instructions

5.1 The covers can be removed and washed by hand or machine in 30ºC water with neutral detergent.
5.2 Do not spin, and never tumble dry in an electric clothes dryer, only dry in the air.
5.3 The harness and plastic parts can be wiped by wet cloth with lukewarm soapy water. Do not use chemical reagent, bleacher or
corrosive substance.
5.4 The cover can be reused after cleaning.
5.5 If in doubt, consult either the child restraint manufacturer or the retailer. Do not use any accessories and replacement parts
which are manufactured without the permission of our company.
6. Important safety guidance
• Each modi cation should be submitted to the homologation of the responsible authorities.
• Alterations of the child car seat, cannot diminished the safety and function of the seat.
• Any changes that can diminish the safety of car seat that will not be guaranteed by manufacturer.
• Making sure that the child car seat is always fastened to the car seat with the belt, even if it is not in use.
• Do not leave any loose objects on the back seat of your car, as they will become dangerous to your child if you brakes suddenly.
• If the safety seat is involved in an accident, it must be replaced.
• Do not leave the child car seat under high temperatures or baking by the sun which will increase the temperatureof seats and can hurt your
children's skin.
• Never leave your child unrestraint in the safety seat.
• The child and the safety seat are correctly installed and that the safety seat belt is well and strongly fastened.
• If you have any problems regarding the use of your car safety seat, please contact the manufacturer or wholesaler.
• Please keep these instructions. You can put these instructions in your vehicle handbook or insert them into any gap between the cover and
plastic.
ENGLISH

Publicité

Table des Matières
loading

Table des Matières