Items Supplied; Accessories - Weller WST 82 Mode D'emploi

● Similar types of thermoplastic materials have widely
varying thermal behaviour. The molecular structure and
the additives used are dominant factors. It is therefore
necessary to determine temperature data by experiment.
The processing temperature (data sheets, data books) is
useful as a starting point.
Trouble Shooting
If the WST 82 heats unevenly or remains cold, the following
should be checked:
1. Temperature setting
2. Connection to control unit
3. The resistance at plug
Between pins 2 and 4 = approx. 22 Ohm
Between pins 1 and 2 = approx. 9 Ohm
Between pins 1 and 2 = approx. 7 Ohm
If other values are measured, the heater element is
defective.

7. Items supplied

WST 82 KIT1:
Thermal removal of insulation WST 82
T005 87 250 34 Brass wire brush
T005 87 257 42 Cutting knife set 23 mm
T005 87 257 26 Knife set AWG 12, 16, 24
T005 15 032 98 Safety stand
WST 82 KIT2:
Thermal removal of insulation WST 82
T005 87 250 34 Brass wire brush
T005 87 257 36 V-knife set 4,25 mm x 2 mm
T005 15 032 98 Safety stand

8. Accessories

T005 87 257 22 Universal Knife
9 mm x 2 mm
T005 87 257 26 Knife set AWG 12, 16, 24
(2,0; 1,3; 0,51 mm)
T005 87 257 29 Knife set AWG 12, 14, 24, 26
(2,0; 1,6; 0,51; 0,4 mm)
T005 87 257 32 Knife set AWG 14, 18, 22, 26
(1,6; 1,02; 0,64; 0,4 mm)
T005 87 257 36 V-knife set 4,25 mm x 2 mm
T005 87 257 42 Cutting knife set 23 mm
Subject to technical alterations and amendments!
See the updated operating instructions at
www.weller-tools.com.
English
10