König Electronic HC-DT11-12 Mode D'emploi page 4

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
1. Pull the battery cover away from the unit.
2. Remove the battery holder.
3. Use a non-metal pointed tool to remove the battery and insert the new battery with the positive (+)
side facing up.
4. Replace the battery holder.
5. Carefully slide the battery cover back into place.
Warning: Please properly replace the battery away from small children and heat.
Cleaning instructions
Before and after each use, clean the thermometer with a soft cloth and isopropyl alcohol diluted with
water, or wash with COLD soapy water. The unit can be submerged in water or alcohol (waterproof
model only). Do not soak for an extended period time or sterilize by boiling method, gas or steam
autoclaves.
Solution
Dilution with water
Ethanol
70-80%
Isopropyl Alcohol
70-90%
Precautions
1. The thermometer should only be used under the supervision of an adult. It is not a toy for children.
Please keep it out of reach of children.
2. Do not walk, run or talk while measuring the temperature.
3. Store the unit in the protective case when not in use.
4. Do not store the unit where it is exposed to direct sunlight, dust or humidity.
Avoid extreme temperatures.
5. Dropping or subjecting your thermometer to strong shocks should be avoided.
6. Do not attempt to disassemble the unit, except to replace the battery.
Safety precautions:
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
the product to water or moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective
holders and are hereby recognized as such.
Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system
for these products.
To reduce risk of electric shock, this product should ONLY be opened by
an authorized technician when service is required. Disconnect the product
from mains and other equipment if a problem should occur. Do not expose
4
Method
Wipe the probe with the soaked cloth
As above

Publicité

Table des Matières
loading

Table des Matières