Velleman AM6621 Mode D'emploi page 4

1. Use a ball pen and push the programming switch until the LED starts flashing then
release and push the switch again until you see the LED slow flashing. It is on
programming output timer mode.
2. Push the transmitter button (The one you just programmed) to your desirable output
time. Following in the output time table.
Action
Press the button of your TX One time
Press the button of your TX Two times
Press the button of your TX Three times Latching output
Press the button of your TX Four times
3. Exit programming output timer mode : Press the other button of your transmitter
(The one you did not program), to exit programming output timer mode. Or you may
wait for 15 seconds to allow the system automatically exit the mode.
PROGRAMMING OUTPUT TIMER
1 second timer
Momentary pulse output 2 flash ... pause
3 minutes timer
Output Timer
1 flash ... pause
3 flash ... pause
4 flash ... pause
LED Status