Regulatory Compliance - Acksys WLg-ABOARD V3 Guide D'installation Rapide

9 status LED indicate:
LED Color
Power 1 Green
Power 2 Green
Diag Red
WLan
Blue
Tx/Rx
LAN 1
Green
10/100
LAN 1
Green
100
LAN 2
Green
10
LAN 2
Green
100
Red/
C-KEY
Green
The 10 BASE-T or 100 BASE-Tx Half/Full duplex mode is negotiated
according to 802.3u recommendations.
The unit conforms to the following council Directives :
N°
1999/5/CE
73/23/CE
2004/104/CE
The device has been certified to comply with the European directives and is
appropriately CE marked.
N°
EN61000-6-2
EN61000-6-4
EN301-489-17
EN300 328
EN301 893
EN50155
EN50121-3-2
EN60068-2
EN61373
MIL-STD-810F
UTAC E2
The device also complies with Part 15 of the FCC rules (Common testing
standard for most electronic equipment).
LEDs definition
This led is ON when a power supply is connected to
pin 3/pin 4 of the power connector.
This led is ON when a power supply is connected to
pin 1/pin 2 of the power connector.
This led indicates the unit operational state.
ON : Failed, OFF : OK. It stays ON for less than 10s
after power is applied then it goes OFF.
Flashing for WLAN Tx/Rx activity.
This LED is ON when LAN1 is connected to a 100
BASE T device. It remains OFF when connected to
a 10 BASE T device.
ON when the LINK to the remote device on LAN1 is
established, and flashing for Tx/Rx activity.
This LED is ON when LAN2 is connected to a 100
BASE T device. It remains OFF when connected to
a 10 BASE T device.
ON when the LINK to the remote device on LAN2 is
established, and flashing for Tx/Rx activity.
Off: no C-Key is detected.
Red: the C-Key data is invalid or corrupted.
Green: the C-Key data is valid.
Blinking: during reads and writes to the C-Key.

Regulatory compliance

Title
Radio and Telecommunications Terminal Equipment
Directive (R&TTE)
Low voltage directive
EMC for motor vehicles
Title
EMC emission, industrial grade
EMC Immunity, industrial grade
EMC for radio equipment 2.4Ghz & 5GHz
Electromagnetic compatibility and Radio spectrum
Matters (ERM) ; Wideband transmission systems, 2.4
GHz ISM band
Broadband Radio Access Networks (BRAN) ;
5 GHz high performance WLAN
Railway, Electronic equipment used on rolling stock
(EMC, Climatical, Mechanical shocks & vibration)
Shocks & vibrations according to 514.5 and 516.5
methods
CE standard for electronic equipments installed aboard
vehicle
Description
-12-