Important; Electrical Connection - IGNIA LIGHT OnLED RGB Manuel D'installation Et D'entretien

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to
be implemented for installation and start-up. Therefore, the installer as well as the user must read the instruc-
tions before beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the Projector OnLED, follow the instructions provided below:

1. ELECTRICAL CONNECTION

The projectors are supplied with a 2-wire 1.5mm2 Cu H07RNF cable.
You should make sure that the voltage received by the lamp is never more than 12V~AC, by a safety transformer. The
transformer must be sized to provide the VA for each LED projector that is connected. See power table, last page.
2. CONTROL SYSTEMS OF THE LED PROJECTORS: by means of the OnLED Series
The LED projector can be controlled in two differents ways: either by a normally closed pushbutton or by mens of the
modulator and/or remote control. See figures on page 12.
2.1. OnLED ECO: NC (normally closed) pushbutton control
The pushbutton of control must support the power of all the projectors that we connect to it. In the case of the pushbutton
with code I0831 it must be connected in the primary one of the transformer and holds a maximum power of 700VA.
The pushbutton control enables you to create different lighting scenarios inside the pool with two function modes:
Fixed colour: Selection of a fixed colour from seven possibilities
Automatic colour sequence: Selection from among seven programmes of colour sequences. Each programme is
defined by the duration of each colour and of the transition from one colour to another, according to the following table:
SEQUENCE
1
2
3 Magenta
4
5 Magenta
6 Yellow
7 Green
Each press of the pushbutton changes a colour or sequence. The cycle of colours and sequences is rotary. For example,
if you are in colour 6, by pressing once you will go to colour 7. If you press once again, you will go to sequence 1. If you
are in sequence 7, press once and you will go to colour 2 which is Red.
Colour 1 is white and is reached by one long press.
2.2. OnLED TOP: control by means of Modulator
The modulator (code I0826) must support the power of all the projectors that we connect to it, the maximum power that
it supports is 900 VA.
The Remote Control – Modulator – Transformer – Led Projector unit enables you to create different lighting scenarios
inside the pool with two function modes:
COLOUR Nº
Red Blue
Red Green
Cyan
Red Blue
Cyan
Magenta
Red
COLOUR
1 White
2 Red
3 Blue
4 Green
5 Magenta
6 Cyan
7 Yellow
ORDER OF COLOURS
Green Magenta
Cyan
Yellow
Green
Yellow
Cyan
Blue
2
Cyan
Blue Magenta
- -
- -
- -
- -
- -
Yellow
Yellow
-
-
-
-
-