Hardware Installation - IOGear GTD737 Guide De Démarrage Rapide

3

Hardware Installation

Please follow steps below to ensure the optimal performance:
Step 1
Connect the included AC Adapter to the AC input port on the docking station.
Step 2
Connect a DisplayPort cable from the docking station to the external
DisplayPort Monitor for up to 4K of resolution.*
Step3
Connect second Displayport cable from docking station to external Displayport
monitor if Dual screens are desired.
Step 4
Connect your USB-C peripherals such as a card reader or hub to the USB-C
expansion ports.
Step 5
Connect your USB peripherals such as keyboard or mouse to the USB-A ports
on the docking station.
Step 6
Connect your Ethernet cable to the Gigabit Ethernet port.
Step 7
Connect your headphones to the 3.5mm headphone input port.
Step 8
Make sure your Thunderbolt 3 or USB-C DP Alt-mode computer is turned on.
Connect the included Thunderbolt 3 cable from the host laptop's Thunderbolt 3
or USB-C DP alt mode port to the rear Thunderbolt 3 port.
*Note: Laptops using USB-C DP Alt-mode ports will run dual monitors up to 1080p on
Windows and dual 4096 x 2160 @ 30hz (Mirrored) on Mac OS.