SCAN MODE OPERATION
You can save channels into memory and then use scan mode
to monitor those channels from lowest to highest. If the radio
detects a signal on a channel, it stays on that channel as long
DV WKH VLJQDO LV UHFHLYHG ZKHQ WKH VLJQDO VWRSV WKH UDGLR
continues scanning.
When it detects a signal, the radio
stays on the channel until you press
the CH
or CH
button or the
08
10
11
12
The radio scans about
5 channels in 0.5 seconds.
h
x To activate scan mode, press SCAN MEM.
x You must have at least two channels in memory to start a
scan.
x To save a channel into memory, select the channel, then
press and hold the SCAN MEM key. The MEM icon displays
whenever you tune to that channel.
x To remove a channel from memory, set the radio to that
channel, then press and hold the SCAN MEM key. The MEM
icon no longer displays.
x :KHQ WKH UDGLR VWD\V RQ D FKDQQHO SUHVV CH
leave that channel and resume scanning.
x To end the scan, press the SCAN MEM NH\ DJDLQ WKH UDGLR
remains on the last scanned channel.
^
t
,I \RX DFWLYDWH :HDWKHU $OHUW :DWFK ZKLOH LQ VFDQ PRGH SUHVV
and hold WX ALERT), the radio checks the most recently-
used weather channel every seven seconds, then continues
E-20
Uniden Atlantis 155 Owner's Manual
Resume
signal stops.
scan
13
14
15
t
17
or CH
to