Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. oVerVieW
a. cover.
B. harness pads.
C. harness straps.
d. harness buckle.
e. Buckle pad.
F. harness adjuster strap.
G. child seat gradient adjuster.
H. abdominal belt hook.
i. Diagonal belt hook group 0.
J. harness strap slot.
K. harness pad connector.
l. Metal harness connector.
M.user manual´s poquet.
n. locking clip.
o. childs´s seat base group 0 & 1.
P. Diagonal belt hook group 1.
3. installinG CHild seat. GrouP 0.
WarninG
do not use the child seat on a passenger seat fitted with
an active airbag.
1. recline the seat as posible. to adjust the
reclining position of the child seat, pull the red
handle forward until you reach the required
position (3.1).
2. take off the
(o)
basic and change is postion,
then press it outside you will hear a "click"
(3.2).
3. install the child seat rearward facing (3.3).
4. Fasten the child seat by thread the lap bel and the
diagonal belt throught the belt guide slot.thread
the diagonal belt throught the
arrow on the back, and thread the lap belt
28
only suitable for Group 0,
approx. 0 to 9 months (0-10 Kg.)
(i)
slot with blue
throught the slot
(H)
(3.4, 3.5, 3.6, 3.7 & 3.8).
5. Fasten the seat belt into the vehicle´s buckle until
it "clicks", making sure the child seat is properly
installed (3.9).
6. tighten the lap belt and diagonal shoulder belt,
then place the red safety clip
shoulder belt tongue as near to the vehicle
anchor point as possible without touching it!
(3.9, 3.10, 3.11 & 3.12).
Make sure the vehicle's safety belt is not twisted,
also check that the seat cover does not impede the
movement of the vehicle's safety belt or prevent the
installation of the seat in any way. to release your
child unbuckle the vehicle safety belt as described
in the instructions.
ensure that the belt has no slack.
4. installinG CHild seat. GrouP 1.
installing the child seat forward facing can only be
maid if the child is more than 9 kg.
only suitable for Group 1, approx.
WarninG
9 months to 4 years of age (9-18 Kg.)
1. to install as Group 1, the seat must be in its most
upright position to adjust reclining angle of the
child seat, pull the control red handle
you until the desired position is achieved (3.1).
2. take off the
basic and change is postion,
(o)
then press it inside you will hear a "click" (4.1).
3. Fit the child seat into the vehicle´s seat, making
sure it is firmly pressed against the vehicle seat
backrest (4.2).
4. pass the lap belt through the
in the seat backrest and fasten the safety belt to
with blue arrow on the base
(n)
on the diagonal
(J)
towards
(i)
and
(P)
guides
29
Publicité
Table des Matières
