Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 1 M8 nut.
- 3 BHC 6×10 screws.
- 1 BTR 8×120 screw.
- 3 rubber washers.
- 3 M6 nuts.
- 3 fixing brackets.
Assembly
- Attach the front brackets using the BTR 8×120 screw and the M8 nut on the lower
engine hole situated next to the hole filter (see photo).
- Fix the rear bracket to the exhaust/frame fitting point (see photo).
- Do not tighten up completely at this stage so as to allow adjustment at the fixing points
later.
-Position the belly pan and attach it at the three fitting points, using the three BHC
screws, the three M6 nuts and the three rubber washers. Move the belly pan backwards
and/or forwards as required to ensure that it is well clear of the exhaust pipes.
- Tighten up the bracket screws, along with the three belly pan screws.
* Painted and varnished parts are not guaranteed to withstand high pressure washing which can damage them.
* According to the technical data of our paintwork suppliers, we advise waiting one month to obtain a complete polymerization of varnish.
* Accessories fitted on the motorcycle, modified, or damaged through poor assembly or an incompatibility with other parts (tyre, complete line / silencer of exhaust system, casing protection or the others...) will not be
considered any more as new and thus will be neither retaken nor exchanged under guarantee.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal road use.
FITTING INSTRUCTIONS
SV 650 1999/2002
ATTENTION
« BELLY PAN »
Publicité
