Werner WH2200 Série Instructions D'installation page 6

STEP 8:
CRITICAL STEP: Proper measurement and cutting of the ladder rails is important for
safe operation of your attic ladder. For instructional video, go to www.wernerco.com.
ADJUSTING STAIRWAY TO CEILING HEIGHT
Pull stairway down applying pressure so that hardware arms are
fully extended. Open the stair sections, folding bottom section
under the middle section. The top and middle sections should
form a straight line. Aligning your ruler on the same plane as the
two upper sections, measure the distance from the bottom of the
middle section to the oor on the front and back (see FIGURE
4A). Mark the distances obtained on the front and back sides of
the ends of the bottom section.
Trim bottom sections at the proper length and angles by cutting
across them. With the bottom section cut to the proper length and
angle, joints will be tight at each section with weight on the stairs.
If either of the trim lines pass through any part of the
step, remove the 14 gauge nail between the rail-to-step
connection on both sides of ladder section. Once the
nail is removed, cut the rail ush to the underside of the
step on both sides of section (see FIGURE 4B). Gently
tap the tread side of the step with a hammer to remove
(see FIGURE 4C).
FIGURE 4B
WARNING: The bottom section must t ush with the oor. Failure to cut properly could result in undue stress on the
component parts of the stairway, resulting in serious injury (see FIGURES 5A, 5B and 5C).
FIGURE 5A - CORRECT SETUP
STEP 9:
TRIMMING THE STAIRWAY OPENING
A. Select a molding that blends with the trim in your home: a 5/8" or 2-1/4" Clam Shell
molding is a popular choice.
B. Leave a 3/8" space between the door panel and the trim at the hinge end of the
stairway to provide clearance when the stairway is opened.
C. The balance of the trim may be placed approximately 1/8" from the edges of the
plywood door panel.
D. Your installation is complete.
6
PIANO HINGE
BRACKETS
CUT ACCORDING
3
TO MEASUREMENT
TRIM LINE
FIGURE 4C FIGURE 4A - ADJUSTMENT TO CEILING HEIGHTS
FIGURE 5B - INCORRECT SETUP
Adjusting your stairway is
accomplished in 3 easy steps:
1. MEASURE 2. MARK 3. CUT
PIVOT PLATE
B
B
A
2 MARK MEASUREMENTS ON BOTTOM
SECTION TO MAKE TRIM LINE
FIGURE 5C - INCORRECT SETUP
CAUTION: SAFETY TIP
Make certain the stairway is
aligned properly before each use.
END BOARD
1
MEASURE THESE
DISTANCES
A