Maintenance & Service - Evolite Infinium 2200 RGB Mode D'emploi

Display
CH11/23
dot
Color
CH12/24
setting
Analog
CH13/25
color
 Maintenance & service
o Cleaning
The cleaning of internal must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in
which the fixture operates: damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt on the fixture's
optics.
 Clean with soft cloth using normal glass cleaning fluid.
 Always dry the parts carefully.
 Clean the external optics at least every 20 days. Clean the internal optics at least every 30/60 days

There is no replaceable parts inside. DO NOT OPEN THE FIXTURE
o Troubleshooting
Following are a few common problems that may occur during operation. Here are some suggestions for easy troubleshooting:

The fixture does not work, no light
o
Check the connection of power and main fuse.
o
Measure the mains voltage on the main connector.

Not responding to DMX controller
o
DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
o
If the DMX LED is on and no response to the channel, check the address settings and DMX polarity.
o
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the fixture or the previous
one.
o
Try to use another DMX controller.
o
Check if the DMX cables run near or run alongside to high voltage cables that may cause damage or interference to
DMX interface circuit.

Some fixtures don't respond to the easy controller
o
You may have a break in the DMX cabling.

No response to the sound
o
Make sure the fixture does not receive DMX signal.
o
Check microphone to see if it is good by tapping the microphone.

No light out
o
Please check if Red Emergency Button is up or down
Infinium 2200 RGB User Manual Ver. 1.00
1~127
128~255
0~7
8~63
64~95
96~127
128~159
160~191
192~223
224~255
0~255
Scanning speed select
Original color
Select every single color
Select color changing effects and speed
Select flowing color effect & speed
Select color drawing effect & speed
Select analog colors (only valid under CH12 with 0~7 value)
Page 20