Master/Slave Mode; Maintenance & Service; Cleaning; Troubleshooting - Evolite Cyclop Mode D'emploi

o Master/ Slave Mode
Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units.Proper performance it may be necessary to use a terminator at the last fixture. For more information
about terminators.
 Maintenance & service
o Cleaning
The cleaning of internal must be carried out periodically to optimize light output. Cleaning frequency depends
on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause
greater accumulation of dirt on the fixture's optics.
 Clean with soft cloth using normal glass cleaning fluid.
 Always dry the parts carefully.
 Clean the external optics at least every 20 days.
o Troubleshooting
Following are a few common problems that may occur during operation. Here are some suggestions for easy

troubleshooting:


The fixture does not work, no light
o
Check the connection of power and main fuse.
o
Measure the mains voltage on the main connector.

Not responding to DMX controller
o
DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
o
If the DMX LED is on and no response to the channel, check the address settings and
polarity.
o
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the
fixture or the previous one.
o
Try to use another DMX controller.
o
Check if the DMX cables run near or run alongside to high voltage cables that may cause
damage or interference to DMX interface circuit.
Cyclop Manual Ver. 1.00
DMX
26
Page