Switching On; Setting The Temperature; Automatic Switch-Off; Switching Off - Boso Bosch+Sohn bosotherm 1200 Mode D'emploi

4.3 Switching on

To switch the heating pad on, set the sliding switch for ON/OFF and temperature settings to setting 1, 2 or 3.
The temperature settings (4) are illuminated when switched on.

4.4 Setting the temperature

Level 0: OFF
Level 1: minimum heat
Level 2: medium heat
Level 3: maximum heat
NOTE
The fastest way to warm up the heating pad is to initially set the highest temperature setting.
NOTE bosotherm 1500
These heating pads have a fast heating function, which allows the pad to warm up faster
in the first 10 minutes.
WARNING
If the heating pad is being used over several hours, we recommend
that you set the lowest temperature setting on the controller to avoid
overheating the heated body part, which may lead to burns to the skin.

4.5 Automatic switch-off

This heating pad is equipped with an automatic switch-off function. This turns off the heat sup-
ply approx. 90 minutes after the initial use of the heating pad. The temperature setting display
then starts to flash. So that the heating pad can be switched back on, the sliding switch for ON/
OFF and temperature settings (5) must first be set to setting "0" (OFF). After about 5 seconds
it is possible to switch it on again.

4.6 Switching off

To switch the heating pad off, set the sliding switch for ON/OFF and temperature settings to setting "0" (OFF).
The temperature settings are then no longer illuminated.
NOTE:
If the heating pad is not in use, switch the sliding switch for ON/OFF and temperature settings to setting
"0" (OFF) and unplug the mains plug from the socket. Then disconnect the controller from the heating
pad by unplugging the plug-in coupling.

5. Cleaning and maintenance

WARNING
Before cleaning, always remove the mains plug from the socket first. Then disconnect the controller
from the heating pad by unplugging the plug-in coupling. Otherwise there is a risk of electric shock.
CAUTION
The controller must never come into contact with water or other liquids, as this may cause damage.
• To clean the controller, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
• The textile cover can be cleaned in accordance with the symbols on the label and must be removed from
the heating pad prior to cleaning.
• To clean the plastic protective cover on the heating pad, use a damp cloth.
13
90
min
STOP