Intended Use; Operation; Safety; Initial Use - Boso Bosch+Sohn bosotherm 1200 Mode D'emploi

• Do not pull, twist or make sharp bends in the cables.
• Please check this heating pad frequently for signs of wear and tear or
damage.
If any such signs are evident, if the heating pad has been used incor-
rectly or if it no longer heats up, it must be checked by the manufac-
turer before being switched on again.
• If the mains connection cable of this device is damaged, it must be
disposed of. If it cannot be removed, the device must be disposed of.
• While the heating pad is switched on, the following conditions must
be observed:
– Do not place any sharp objects on it.
– Heat sources, such as hot water bottles, heating pads or similar,
must not be placed on the pad.
• The electronic components in the controller warm up when the
heating pad is in use. For this reason, the controller must never be
covered or placed on the heating pad when it is in use.
• Always observe the notes on operation (section 4), cleaning and
maintenance (section 5) and storage (section 6).
• If you should have any questions about using our devices, please
contact Customer Services.

3. Intended use

CAUTION
This heating pad is only designed to warm up the human body.

4. Operation

4.1 Safety

CAUTION
• The heating pad is fitted with a SAFETY SYSTEM. This sensor technology provides protection against
overheating across the entire surface of the heating pad with an automatic switch-off in the event
of a fault. If the SAFETY SYSTEM has switched off the heating pad, the temperature settings are
no longer illuminated when switched on.
• Please note that for safety reasons, the heating pad can no longer be operated after a fault has
occurred and must be sent to the specified service address.
• Do not connect the defective heat pad with another controller of the same type. This would trigger
a permanent switch-off via the controller safety system.

4.2 Initial use

CAUTION
Ensure that the heating pad will not bunch up or become folded during use.
• First, connect the controller to the heating pad by inserting the plug-in
coupling.
• Then plug the mains plug into the socket.
12