Settings; Adjusting The Water Temperature - Jaga CLIMA CANAL - JDPC Manuel D'utilisation

3. SETTINGS
3.1. ADJUSTING THE WATER TEMPERATURE
3.1.1. Adjusting the maximum water temperature for cooling
By reducing the water temperature setting, the unit will start later. If the water temperature is set
higher, the unit will start sooner .
1. Start setup mode: press and hold the [-] button until
2.
1
-
The blue LED flashes quickly when the minimum
temperature is reached.
Automatic control: The green LED
rature
3. Exit setup mode: hold the [-] button until
3.1.2. Adjusting the minimum water temperature for heating
By increasing the water temperature setting, the unit will start later. If the water temperature is set
lower, the unit will start sooner .
In combination with a heat pump, it may be necessary to reduce the water temperature .
1. Exit setup mode: Press and hold the [+] button until
2.
1
-
The blue LED flashes quickly when the minimum
temperature is reached.
Automatic control: The green LED
rature .
3. Exit setup mode: press and hold the [+] button until
After 30 seconds, the new settings are automatically saved and the device returns to the
selected mode.
JAGA N.V. | CLIMA CANAL - JDPC | MANUEL | 11.02.2021 | V.01
Briefly press the [-] or [+] button to adjust the set tempe-
12 ̊ C 14 ̊ C 16 ̊ C 18 ̊ C
lights up when the water temperature (supply water) is lower than the set tempe-
the blue LED
Briefly press the [-] or [+] button to adjust the set tempe-
rature .
24 ̊ C 26 ̊ C 28 ̊ C 30 ̊ C
lights up when the water temperature (supply water) is lower than the set tempe-
the blue LED flashes 5x and release .
rature .
20 ̊ C 22 ̊ C 24 ̊ C
The red LED flashes quickly when the maximum
flashes 5x and release .
the red LED flashes 5x and release .
32 ̊ C 34 ̊ C 36 ̊ C
The red LED flashes quickly when the maximum
the red LED flashes 5x and release .
1
-
26 ̊ C
temperature is reached.
1
-
38 ̊ C
temperature is reached.
EN
25