Connecting The Power Supply; Switching The Smart Tv On And Off; Channel Search When Switching On For The First Time - Medion Life X14020 Guide De Démarrage Rapide

 Connect the antenna cable from either the house aerial/the analogue cable connection, the
DVB-T antenna or the DVB-C connection to the antenna connection on the smart TV
You also have the option of connecting a digital satellite system to the connection labelled LNB.
 Screw the F connector of a coaxial antenna cable onto the connection on the smart TV.
To receive encrypted/subscription channels you will need to use a CI module and
an appropriate card. Insert a CI module (available in specialist shops) into the slot
provided for this purpose on the left-hand side of the device (Common Interface).
You can then insert the card from your provider into the CI module.

3.5. Connecting the power supply

 Connect the mains plug on the device to an easily accessible 220 - 240 V ~ 50 Hz mains socket.
3.6. Switching the smart TV on and off
 Set the power switch on the bottom of the device to
and the display on the front will light up.
 To switch on the device, press
− on the remote control: the Standby/On button , one of the number buttons or one of the
  buttons;
P /
− on the device: the multifunction button .
 Use the Standby/On button
mode. Although the device has been switched off, it will continue to consume electricity.
 Use the mains switch to turn off the device (OFF position). The device will continue to consume
power as long as it is connected to the mains network.
If the device is not receiving an input signal, it will automatically switch to standby
mode after five minutes. A countdown timer will appear on the screen until this
time. This function is not available for all sources
3.7. Channel search when switching on for the fi rst time
When you switch the device on for the first time, you will be guided through the
menu.You can call up and carry out the first-time installation again at any time via
INSTALLATION
the menu
INSTALLATION > FIRST TIME INSTALLATION .
 Use the  keys to select the language..
After confirming the selected language with
10
O N
on the remote control to switch the device back into standby
O K the initial installation will begin
. The device switches to standby mode
.
FIRST TIME