Eaton Metalux MS Série Instructions D'installation page 2

Installation Instructions – Standard Highbay Motion Sensor (MS)
INSTALLATION
Highbay Motion Sensor
1. Insert motion sensor and bracket to pre-installed
screws on fixture endplate. (Figure 1.)
2. Secure bracket by tightening screws on fixture
endplate. (Figure 2.)
3. Rotate motion sensor reading surface (LENS) so that it
is parallel with floor. (Figure 2.)
4. Push motion sensor forward to lock sensor into
position.
Figure 1.
Figure 2.
2
EATON
ADF140678
Screws (pre-installed)
Motion Sensor and Bracket Assembly
Installation instructions
All Other Motion Sensor
1. Insert motion sensor and bracket to pre-installed
screws on fixture endplate. (Figure 1.)
2. Secure bracket by tightening screws on fixture
endplate. (Figure 2.)
3. Rotate motion sensor reading surface (LENS) so that it
is parallel with floor. (Figure 2.)
Fixture
Motion Sensor Reading Surface