Philips sonicare FlexCare+ 900 Série Mode D'emploi page 9

Masquer les pouces Voir aussi pour sonicare FlexCare+ 900 Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

You hear 1 beep to indicate the Quadpacer has been deactivated or
,
you hear 2 beeps to indicate the Quadpacer has been activated.
Cord wrap on deluxe charger (specific types only)
If your type includes the deluxe charger cover and base, the travel charger
is pre-installed inside the cover. If you want to shorten the mains cord, you
can store excess cord in the cord wrap feature built into the charger base.
1
To separate the charger cover from the charger base, press the two
grey snap bars on the charger base and pull the white charger cover
upwards.
2
Wrap excess power cord around the grey charger base as shown in
the picture. Be sure to wrap the cord on the inside of the two snap
levers.
3
When you have stored the excess cord, guide the mains cord
through the small groove in the rear of the grey charger base.
4
To reattach the charger cover, press it down over the charger base
until it snaps into place.
Tip: For extra convenience during travel, you can remove the travel charger and
use it without the charger cover and charger base.
Cord wrap on sanitiser with integrated charger (specific types
only)
-
If your type includes the sanitiser, you can store excess cord in the cord
wrap feature built into the bottom of the sanitiser.
EnglisH
9

Publicité

Table des Matières
loading

Table des Matières