Rear Panel - Ramiaudio TEL300 Manuel Utilisateur

REAR PANEL

IN Remote
100-240V 50/60Hz T 1A
14W
230V 50/60Hz T 250mA
I
A - Mic input on 3 pt XLR female jack. From -56 dbu to -26 dBu ) (Integrated phantom supply)
Warning : Do not plug the mic in the front and the back at the same time.
B - Balanced monophonic line input on XLR 3 pt female jack. (+6dBu)
C - Balanced monophonic output (correspondent's signal only) on 3 pt XLR jack.
D - Balanced monophonic output (mixing of the correspondent's send / return) on 3 pt XLR jack.
E - RJ11 socket for handset. Two wiring standards available
F - RJ11 jsocket for connection to the telephone network.
G - TEL 300 external remote control on female SUB-D15 jack:
 Remote control for taking a line : Put a switch between pins 1 and 2.
 Return indicator for taking a line (confirmation) : Wire up the indicator between pins 1
and 3.
 Now, balanced line input and balanced output "correspondent's signal" are accessible
on the REMOTE connector (DB15)
Warning : Don't use in the same time XLR input/output and Sub-D 15 input/output.
H - Choice of remote control.
 Depressed: Continuous loop. TEL300 in on air as far as the loop is closed
 Pressed:
I - Mains connector
Rami
TELEPHONE
Pulse
Hold
LINE
REMOTES
H G F
LINE OUT
RETURN ONLY
LINE IN
Pulse. A pulse picks up, the next one hangs up
www.ramiaudio.com
MODEL
PHONE
TEL 300
TEL 300 S
TRANSFORMERS
INPUTS
Std A Std B
OUTPUTS
E
.
Indicator 24V/20mA
Signal 7
Return 15
GND 8
8
15
GND 14
Return 6
Signal 13
17
OUTPUTS
MIX RETURN ONLY
Made in France
D C
-
+
Continuous or pulse dry loop
according to H
1
Sub-D 15 pts
9
male
INPUTS
PUSH PUSH
LINE MICRO
B A
TEL300