Selecting Digital Audio Output - NAD L56 Manuel D'installation

Each DVD disc has a variety of audio output options. Set the player's
Digital Audio Output according to the type of audio system you use.
1 At the SETUP screen, press
and press
2 Press to select the desired output and press ENTER.
DOLBY DIGITAL/PCM
Select "DOLBY DIGITAL/PCM"if an active digital output is supplied to the
Dolby Digital decoder, (or an amplifier or other equipment with a Dolby
Digital decoder).
STREAM/PCM
Select "Stream/PCM" if an active digital output is supplied to an
amplifier or other equipment with DTS decoder, Dolby Digital decoder
and MPEG decoder.
PCM
Select "PCM" if an active digital output is supplied to an amplifier or
other equipment with linear PCM only (or MD recorder or DAT deck).
NOTES
• When you are not using the player's digital audio output, don't select
any of the options.
• If an active digital audio output signal is supplied to an receiver or
other equipment without a corresponding digital decoding capability,
a very loud noise may be produced which could permanently
damage the speakers.
• The DTS DVD disc sound is played back only when the DVD player is
connected to a receiver with a DTS decoder.
to select Digital Audio Output
SELECTING DIGITAL AUDIO OUT
Playback Disc
Stream / PCM
96 kHz Linear PCM
PCM DVD
DTS DVD DTS Bit Stream
Dolby Digital DVD Dolby Digital Bit
Stream
MPEG DVD MPEG Bit Stream
Audio CD PCM
DTS Audio CD DTS Bit Stream
Initial Settings
OUTPUT
Dolby Digital / PCM only
PCM
PCM PCM
No Output Audio Output
Dolby Digital Bit PCM
Stream
PCM PCM
PCM PCM
DTS Bit Stream DTS Bit Stream
43
GB