TEMPUR-PEDIC ERGO Manuel Du Propriétaire page 13

installation guide
STEP 7
Carefully flip the base over on to its legs. Important: Two
people are required to move the bed base. Do not drag
across the floor. Do not rest frame on its side, excessive
pressure may damage the legs.
STEP 8
Plug the power cord into a power source. A surge
protector is recommended.
STEP 9
Ensure batteries are correctly installed in the back of the
remote.
Quickly test functions to verify proper setup before placing
mattress on base. Return the base to a flat position before
placing the mattress on top.
STEP 10
To install the mattress retainer bar, insert each end of the
bar into the holes at the foot of the platform.
STEP 11
Raise head of the base to maximum articulation.
For Tempur-Pedic customer service call: U.S. 1-844-309-3597 | Canada: 1-800-887-4321 | México: 01-722-273-1810
STEP 12
Remove Sleeptracker Sensor(s)
®
from twist ties. Queen, Full and
King/Cal King bases will have 2
sensors each.
STEP 13
Insert Sleeptracker Sensor(s) into pocket on top of base.
®
Secure pocket to velcro strip.
STEP 14
Find the QR code included on the Let's Get Started card
and scan using a QR code reader app from your phone for
help installing the Tempur-Pedic
Information can also be found at :
https://www.sleeptracker.com/getapp/tempur
Setup is now complete! Test all functions on remote.
Sleeptracker app.
® ®
9