Fitting The Door Panel - Brandt VH900WE1 Guide D'installation

2 / INSTALLING YOUR DISHWASHER
EN

• FITTING THE DOOR PANEL

- Measure the distance between the floor and
the bottom of the door panel on the adjacent
unit (Dimension B, on Fig. 6.1).
- Measure the distance between the floor and
the marking on the bottom of the door panel
(Dimension A).
- Calculate Dimension D = A - B, and draw a
line for Dimension D on the back of the panel
at the bottom (Fig. 6.2).
- Set the positions for the two screws at
262mm from the wood panel's axis and insert
P7
both screws (Fig. 6.2).
- Position your door panel by engaging the 2
screws in the holes in the dishwasher's door
(Fig. 6.3).
- Place the wood panel on the door, slightly
compressing the spacers if necessary (Fig.
6.3).
- Open the dishwasher's door while holding
the panel firmly against the door. Centre the
wood panel laterally with respect to the
control panel, if necessary. Insert the 2
P8
screws (Fig. 6.4).
- If there is a problem with screwing, offset the
P7
screw by 22mm.
- If necessary, add two additional screws
by replacing the 2 internal screws on the
inside of the door (stainless steel screws)
(see the dotted arrows).
Warning:
If the wood panel is very hard, ensure
that you make a hole in advance before scre-
wing the panel on.
NB:
If your appliance is supplied with a
sound insulation sheet, glue this on before
installing the door panel.
Fig. 6.1
Fig. 6.2
P8
,
Fig. 6.3
Fig. 6.4
21
D
D
✍