System Requirement - i-tec MYSAFEU314 Mode D'emploi

EN
SPECIFICATION
• External USB 3.0 enclosure for 2.5" SATA I / II / III hard disk
drives
• Transfer interface: 1x USB 3.0
• Compatible with all 2.5" SATA HDD (with height up to 9.5 mm)
• Backward compatible with USB 2.0 devices
• Supports the following speed data rates: SuperSpeed (5Gbps)
/ HighSpeed (480Mbps) / FullSpeed (12Mbps) / LowSpeed
(1.5Mbps)
• Plug & Play
• Active LED to indicate HDD status (it shines – HDD is
connected, it twinkles –
record/reading is underway)
• Power supply 5 V, 900 mA
• Weight: 60 g
• Size: 130 x 74 x 16 mm

SYSTEM REQUIREMENT

• Windows 7/8/8.1/10 32/64bit, macOS 10.x and higher – auto-
matic installation of drivers from OS
• Available USB port (we recommend using free USB 3.0 port to
use maximal speed of HDD).
HARDWARE INSTALLATION OF SATA HDD
Proceed according to following instruction:
1. Open the enclosure and take out the adapter with an built-in
USB cable.
2. Insert HDD, the SATA connector should fit into the slot of
enclosure, and close it.
3. Connect the adapter with an built-in USB cable on the other
side (to HDD) and close the enclosure.
6