Operating The Appliance - TurMix AX 310 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. Operating the appliance

Operation
Setting up
– Place on a flat, stable and waterproof surface.
– Never place directly under the power socket
– Make sure the machine stands safely and the airflow is not
blocked by e.g. furniture or curtains. Never place near cur-
tains, furniture or walls (risk of damage by moisture).
– Make sure that nobody can trip over the power cable and
that the machine is out of reach of children. Never let children
play with the machine.
Important:
– Only use the humidifier in dry rooms up to 50 m² / 125 m³ and without
extension cable.
Filling the water tank
– Pull out the power plug.
– Fill water carefully and slowly through the opening.
– Note the maximum water level mark («MAX») (on the inside).
Do not exceed the maximum water capacity of 5 litres!
Caution!
– Use tapwater only. Never use mineral water or softened
water! Never add salt or anythng else to the water!
Never add water through the air inlet/outlet openings!
– Never put aroma essence in the water tank, only in the aroma container!
Information on evaporation type humidifiers:
– The drier the room air, the more moisture is emitted by the humidifier. This
self-regulation principle prevents excessive air humidity, keeping the rela-
tive humidity between about 45 and 60 %.
– For higher performance in large rooms, place the humidifier near a
radiator (max. temperature no more than 50 °C).
– Air circulation strongly interferes with humidification (e.g. due to open
or loose windows in high rooms).
– Please note that moisture rises with warm air and may cause
undesirable condensation.
22
23
.
– Recommended room air humidities:
50% humidity at 18 °C room temperature
45% humidity at 20 °C room temperature
40% humidity at 22 °C room temperature
Starting up
– Insert the power plug.
– Turn on the power switch
(8.). The LED goes blue.
2-stage power speed selector
– Select the required speed (9.):
– «
» for high speed (daytime operation / blue LED display) or
– « » for low speed (nighttime operation). The respective LED display goes
green.
After use
– Turn off the power switch
(8.).
– Pull out the power plug.
– Empty out the residual water and rinse out the water tank well.
– Regularly clean and maintain the humidifier to ensure hygienic and
trouble-free operation:
– Weekly: clean the housing parts.
– Every 2−3 months: change the filterelements (Art. A52456 / 2 pcs;
change them earlier in case of bad odours, dirt or lime deposits and
noticeably lower humidification performance).
– Let the humidifier dry out completely before storage.
23
DE
DE
FR
IT
GB

Publicité

Table des Matières
loading

Table des Matières