Clock Installation - König Electronic SEC-DVRWCA10 Mode D'emploi

Stamp Date Format: Select YY/MM/DD, DD/MM/YY or
MM/DD/YY. Use the arrow down button to adjust the
settings.
Motion Detection Sensitivity: Select the sensitivity of the
motion detector from 1 to 5. Use the arrow down button to
adjust the setting. (5 is the most sensitive setting, 3 is
recommended).
Light Frequency (Hz): Select the light frequency for your
country. For example, 50 Hz for Europe,60 Hz for United
States. Use the arrow down button to select.
Image Quality: Select the recording quality, High-HD,
Standard or Low VGA. Use the arrow down button to
select.
Overwrite: If the SD card must be overwritten when it is full,
then select ON. If overwritten is not preferred, then select OFF. Use the arrow down button to select.
Bell: When you want to hear a peep sound when pushing the buttons on the remote control or clock,
select ON. If not, select OFF. Use the arrow down button to select.
After adjusting all settings, click on SAVE and push the SET button on the back side of the camera
for 3 to 5 seconds to store the settings in the clock.

Clock Installation:

1. Find a desired location for the clock, near a
wall. The recommended height is around
2 meters.
Note: the camera is mounted inside the clock with
a 17 degree downward angle. The view of the
angle of the lens is 45 degrees.
2. Connect the AC/DC adapter.
Note: view the recorded files after installation to
determine whether the installation height and
angle of view meets requirements.
Operation:
1. Insert an AA 1.5 V battery in
the battery compartment of the
clock.
3
Set the time with the
adjustment wheel.