Technical Specifications; Important - DOMUS LINE TOUCH TW Manuel D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

INSTALLATION MANUAL

TECHNICAL SPECIFICATIONS

Input voltage: 24Vdc
Maximum applicable load: 60W
WARNINGS
Safety is guaranteed if these instructions are followed so they must be kept.
Installation may require involving qualified personnel. Before installing the
device ensure that the environmental conditions are in compliance with
and suitable for product characteristics. Before any operation on the device
disconnect mains power.
INSTALLATION:
Touch TW (fig. 1) can be secured to the surface using the screws (A) and
cover plugs (B) included in the package.
Then connect TOUCH TW to a safe power supply with 24Vdc stabilised
voltage (sold separately) and with power at least 10% higher than the total
load, inserting the male power cable connector (D) into one of the
distributor sockets (E) and connecting the devices (F) to be controlled (only
devices with TW LED) to the output cable (G) in accordance with the
diagram shown in Figure 2.
If more than one device must be connected to the power supply unit ensure
that the total sum of the power absorbed by the devices (check the plate data
EN
shown on the product label) does not exceed the maximum power permitted
both by the dynamic adjustment system and by the Converter.
DOMUS Line guarantees the product only if powered with Converters and
dynamic light adjustment systems supplied by us.
OPERATION:
Switching on and off is carried out simply by briefly touching the indicator
LED (C). By long-pressing you can change the colour shade of the connected
device (tunable function). The selected colour will be stored until the next
adjustment (Colour Memory).

IMPORTANT:

This article must be connected directly to the electronic power supply and
must never be connected downline of other electronic switches. The
sensor must not be installed near electromagnetic or heat sources and not
installed in contact with metal surfaces.
WARRANTY
The warranty on the device is valid only if powered by a power supply
provided by DOMUS Line. The warranty's general terms and conditions for
this device are available at www.domusline.com

Publicité

Table des Matières
loading

Table des Matières