Parts List - ENFORCER SECO-LARM SD-7202GC-PEQ Mode D'emploi

ENFORCER Pushbutton Request-to-Exit Plates
Models:
SD-7202GC-PEQ
• Large illuminated "PUSH TO EXIT" button
• Language easily changed to Spanish or French
• Colored 12-inch wire leads with easy-to-attach
spade lugs for fast installation
SD-7223GW-LQ
Same as SD-7202GC-PEQ, but
with white plastic faceplate
Specifications:
Model
Operating voltage
Current rating
Faceplate
Operating temperature
Built-in timer
LED status indicator
Dimensions
Weight

Parts List:

1x Request-to-exit plate
1x Resistor for 24VDC
(SD-7623-GSTQ only)
1x Installation manual
Changing the Message Plate:
Note: This should be done before connecting
any wires.
1. Carefully twist the switch and bulb assembly
counterclockwise about 20° (see Fig.1), and
then pull it out of the black tube (see Fig. 2).
2. Insert the blunt end of a small tool or rod (e.g., a
screwdriver or pen, ~
the black tube (see Fig. 3). It should slide in
easily all the way until it contacts the inside of
the front lens/message plate assembly. Push
the lens/message plate assembly with your tool
until it pops off (see Fig. 4). Be careful not to
lose the spring.
3. Take off the transparent green lens and insert
the desired message plate.
4. Check that message plate orientation is correct.
5. Snap the lens assembly back on and replace
the switch/bulb assembly.
2
SD-7202GC-PTQ
Same as SD-7202GC-PEQ, but
with additional timer (1~180 sec)
and buzzer output
SD-7202GC-PEQ
10A@250VAC
Brushed stainless
No
3.7-oz (105g)
2x Wallplate screws
2x Replacement message plates
(Spanish, French)
/ " (10mm) diameter) into
3
8
• LEDs Give over 50,000 hours of illumination
• Includes stainless-steel single-gang plate
(except SD-7223GW-LQ, which is white plastic)
SD-7223GW-LQ
12 or 24VDC
White plastic
-40°~167° F (-40°~75° C)
No
No
4 / "x2 / "x2 / " (114x70x70 mm)
1 3 3
2 4 4
2.2-oz (62g)
Figure 1
Switch and
bulb assembly
Figure 3
SD-7623-GSTQ
Same as SD-7202GC-PTQ, but
with additional customizable LED
status indicator
SD-7202GC-PTQ
3A@24VDC
Brushed stainless
Yes
No
4.7-oz (133g)
Colored leads:
5x (SD-7202GC-PEQ)
5x (SD-7223GW-LQ)
2x (SD-7202GC-PTQ)
2x (SD-7623-GSTQ)
Figure 2
Threaded
housing
Figure 4
PUSH
TO
EXIT
PUSH
Transparent
green lens
SECO-LARM U.S.A., Inc.
SD-7623-GSTQ
Yes
5.1-oz (144g)
Switch and
bulb assembly
Message
Plate