Operation Instruction; How To Fix Batteries; Adjust The Time Of Remote Controller; Auto Operation - Zhendre SMC Notice D'utilisation

III OPERATION
INSTRUCTION

1 - How to fix batteries.

• Please press the reset button near the batteries after change
of the batteries. Then remote controller is ready for use.
• After fixing of the batteries, please press
the reset button to set the remote controller ready for use.

2 - Adjust the time of remote controller.

• Open the back cover of remote controller, press CLOCK button,
when the display is flashing «
begin to set the time.
• Press button and press button
• Press « CLOCK » to fix the right time, flashing stop.

3 - Auto operation.

• Press button to start air-conditioner.
• Now, fan speed is auto. Press
• Press button to select auto mode.
• To stop working, please press
• Setting temperature is not shown on remote controller when in AUTO operation.
• When operation shifts from auto into heating or cooling operation, indoor fan speed can be set in low speed,
middle speed, high speed or auto mode.
• After air-conditioner operation for about 15 minutes, if you feel too warm, please push
to adjust the temperature. Thus, you can get most comfort temperature.
• Auto operation is a economical mode, which can select suitable operation mode according room temperature.
Operation mode of louver can be set into Swing flow, Auto, Angle 1, 2, 3, 4, 5.
» and CLOCK,
to change the time.
to select fan speed.
button again.
12
put pole "+"
and "-"correctly.
or